Step a single label across the web or cylinder with tracker bars, registration targets, ink slug and control strip, on every plate. In your browser, 7 day trial, no card.
Step & Repeat takes one label or dieline PDF and steps it across the print web or around the cylinder, adding every mark a flexo press needs: tracker bars, registration targets, an ink slug and a colour control strip on each separation. It applies the cylinder distortion factor for you and centres each label in its repeat cell, splitting the gutter evenly as bleed. Built by a working platemaking studio rather than a software vendor, it runs entirely in the browser with nothing to install, so any packaging printer, anywhere, can lay up a press-ready stepped file in minutes instead of wrestling with imposition software.
Drop in a single label or dieline PDF.
Choose across count, repeat length and which marks to add.
Get a press-ready stepped PDF, distortion applied.
Start with a 7 day trial, full access, no card needed. After that it is Pro R899 a month, Studio R2,499 a month or Enterprise from R7,499 a month; see the pricing page for details.
Yes, it adds registration targets, tracker bars, an ink slug and a colour control strip on every separation.
Yes. It applies the distortion factor based on your repeat length and plate so the print comes out to size.
Flexo Africa